Construction personnel involved in the installation and transportation of large equipment must be familiar with transportation methods. Before transportation, a reasonable and feasible plan should be formulated, and construction must be carried out strictly according to the plan.
In practical planning, based on the orientation of the lifting holes, when the factory building is generally long, it is suitable to install the lifting holes close to the center of the factory and close to the building wall; If the length is not too long, it is suitable to install the lifting hole at one end of the factory building against the gable wall. If lifting holes cannot be set up inside the factory and multi-story lifting holes cannot be uniformly vertical, then consider lifting the equipment outward from a concrete beam from one floor into the workshop.
1. Must comply with contract requirements and practical documents, and comply with current national construction inspection standards. Upon project completion, there should be no omissions. Primary process equipment and supporting equipment must pass joint commissioning and testing, and be ready for production use. Complete submission documents must meet archiving requirements; Production preparation work habits the requirements for production initiation; Environmental protection, occupational safety and hygiene, and fire protection equipment have been installed and installed as required; A few non-primary equipment may not be installed as required by practice, but this does not affect production; Only after the equipment passes trial operation and the quality and quantity of products available for production meet design requirements can inspection be conducted.
Different rescuers are used depending on the type of fire. When spraying the revival agent, the gaseous resurrector evaporates quickly and achieves the intended revival. When spraying gas revitalizer, the maintenance area is completely sealed; after revival, the sprayed gas remains in the maintenance zone. Entry poses life-threatening risks, and harmful gases from the protected area are released outdoors. Ventilation can be described as natural or mechanical ventilation.
Mark and position according to the equipment process layout plan, installation construction drawings, foundation drawings, equipment general scale, and spacing requirements prepared by the process technology department, arrange foundation construction and equipment transfer and positioning. When designing the equipment process layout diagram, the following factors should be considered for equipment positioning. Below is a brief introduction from RunTay Equipment Installation Manufacturer.
Most enterprises have automated machinery and equipment, giving rise to the profession of electromechanical equipment installation. Equipment, roads, pipeline equipment, substation projects of 35kV and below, production of non-standard steel components, and equipment are generally industrial, public, and civil construction projects.
