2022-11-01 17:32:04
The main goal of non-standard automation equipment is to improve production efficiency. It relies heavily on automation rather than worker operations. During production, many steps are completed with higher efficiency and automation than manual labor. Let's take a look at automationEquipment installationSome issues to pay attention to during debugging.
1. Ensure consistent quality.
In non-automated installation processes, if quality remains the same, the number of laborers can be reduced accordingly. In practice, this means replacing the work of installation workers with a small number of adjustment workers, each serving a certain number of automated installation units. In many cases, the production area occupied by installation automation is less than the same product and output value for installation workers, especially in instrument manufacturing, where parts and their components are very small in size.
2. Improve product quality.
Automating the installation process can improve product quality. Installation and commissioning of automated equipment are special requirements for modern production. Installation and commissioning can only be completed during certain installation processes under automated conditions. For example, during vacuum installation, the surface roughness of parts is relatively low, but manual operation is not possible, or the work environment is poor.
3. Installation and commissioning dynamics.
Market requirements for product installation and commissioning are dynamic, but product production should be relatively stable for a period of time. During product development, there are specific requirements for installation and commissioning, and the corresponding operations must be completed according to the production process and drawings.
To balance the opposition between relatively stable production demand and the instantaneous changes in market demand, it is necessary to formulate plans before product design to confirm the functions, technical functions, and development progress of new products. Currently, the equipment producing permanent magnet motors is also non-standard automation equipment. In the recent debugging process, we asked engineers to check the automationEquipment installationThree points to note during debugging.
